Fill Fuel Tank - Toro 07363 Operator's Manual

Figure 14
1. Dipstick
3. The engine uses any high-quality detergent oil
having the American Petroleum Institute -API-
"service classification" SH, SJ or higher. Oil
viscosity – weight – is selected according to
anticipated ambient temperature.
Temperature/ viscosity recommendations are:
• Above 0 degrees F (–20 degrees C)–Use
10W–30.
• Below 32 degrees F (0 degrees C)–Use SAE
5W–30.
Note: SAE 10W40 and straight weight oils (SAE
30, etc.) are not recommended in Kohler engines
due to problems with pump–up of hydraulic lifters
with those oils. Either synthetic or mineral based
oils may be used, but oil drain intervals should be
the same (per recommendations).
4. Pour oil into fill opening until the oil level is up to
the "FULL" mark on the dipstick.
Note: When adding oil, remove dipstick to allow
proper venting, pour oil slowly and check the level
often during this process. DO NOT OVERFILL.
Important: When adding engine oil or filling
oil, there must be clearance between the oil fill
device and the oil fill hole in the valve cover as
shown in Figure 15. This clearance is necessary
to permit venting when filling, which prevents
oil from overrunning into breather.
2. Filler Cap
1. Note clearance
Important: Check level of oil every 8 operating
hours or daily. Change oil and filter initially
after the first 50 hours of operation, thereafter,
change oil and filter every 150 hours. However,
change oil more frequently when engine is
operated in extremely dusty or dirty conditions.
Note: After filling or changing oil, start and run
the engine at idle for 30 seconds. Shut engine off.
Wait 30 seconds and check oil level. Add enough oil
to raise level to FULL mark on dipstick.
5. Install the dipstick firmly in place.

Fill Fuel Tank

Fuel tank capacity is approximately 7 gallons.
The Toro® Company Strongly Recommends The
Use Of Fresh, Clean, Unleaded Regular Grade
Gasoline In Toro Gasoline Powered Products.
Unleaded Gasoline Burns Cleaner, Extends
Engine Life, And Promotes Good Starting By
Reducing The Build–up of Combustion Chamber
Deposits. Minimum Octane Rating of 87.
Note: Never Use Methanol, Gasoline Containing
Methanol, Gasoline Containing More Than 10%
Ethanol, Gasoline Additives, or White Gas Because
Engine Fuel System Damage Could Result.
1. Clean area around fuel tank cap.
2. Remove fuel tank cap (Figure 16).
20
Figure 15