Advertisement
Connecting the Hose to the Pump
1. At the washer-fluid tank, align the end of the hose to
the barbed fitting in the washer pump
Figure 24
1. Washer-pump motor
2. Barbed fitting
2. Push the hose onto the fitting until the hose fully seats
onto the fitting
(Figure
Note: If the hose is too long, shorten it in step
Securing the Wire Harness and Hose (page
(Figure
24).
3. Hose
24).
9
11).
Connecting the Wire Harness at the
Overhead Console
1. At the overhead console, route the 2-pin connector
end of the wire harness for the washer pump through
the hole in the overhead console
of
1. Hole (overhead console)
2. 2-socket connector (cab
wire harness)
2. Align the 2-pin connector of the washer pump wire
harness to the 2-socket connector of the cab wire
harness
(Figure
3. Push the 2 connectors together until the connector
lock snaps secure
4. Route the 2-socket connector of the wire harness for
the washer pump to the left of the overhead console
along the bulb seal at the front of the cab frame
25).
9
(Figure
25).
Figure 25
3. Washer pump wire
harness
4. 2-pin connector (washer
pump wire harness)
25).
(Figure
25).
(Figure
Advertisement
