Advertisement
Securing the Wire Harness and Hose
1. Remove the 2 harness clips that secure the cab wire
harness to the front, left cab frame
Figure 30
1. Push fasteners
2. Harness clips
2. Install 2 push fasteners at the location where you
removed the harness clips in step
Figure
31).
Figure 31
1. Hole (seal mount)
3. Secure the cab harness, washer-pump harness, and
hose with the cable tie portion of the push fasteners
(Figure
31).
Note: Tighten the cable tie only snug. Do not pinch
or collapse the hose.
4. Remove the 3 push fasteners above the driver's door
frame
(Figure
30).
(Figure
30).
3. Bulb seal
1 (Figure 30
and
2. Push fasteners
5. Install 3 push fasteners at the location where you
removed the push fasteners in step
Figure
31).
6. Secure the washer-pump harness and hose with the
cable-tie portion of the push fasteners.
7. At the back of the cab, install 3 push fasteners into the
3 hole across the back panel of the cab
1. Hole (back cab panel)
8. Secure the washer-pump harness and hose with the
cable tie portion of the push fasteners.
9. If needed, shorten the hose as follows:
A. At the washer fluid tank, remove the hose from
the barbed fitting at the pump
B. Cut the hose to remove the excess hose length.
C. Push the hose onto the fitting until the hose fully
seats onto the fitting
Installing the Overhead Console Plug
and the Roof Panel
1. Align the plug that you removed in step
the Roof Panel (page 6)
overhead console
2. Push the plug down into the overhead console until it
is seated
(Figure
3. Align the holes in the roof panel with the clip nuts at
the brackets of the cab frame
4. Assemble the roof panel to the cab frame with the 10
bolts (1/4 x 1 inch) and 10 sealing washers (1/4 inch)
as shown in
Figure 13
Removing the Roof Panel (page
5. Torque the bolts to 520 to 678 N∙cm (41 to 55 in-lb).
Connecting the Battery
1. Connect the negative-battery cable; refer to your
Operator's Manual.
2. Lower the cargo box; refer to your Operator's Manual.
11
4 (Figure 30
(Figure
Figure 32
2. Push fasteners
(Figure
(Figure
24).
3
of
with the top opening of the
(Figure
14).
14).
(Figure
13).
that you removed in step
6).
and
32).
24).
Removing
1
of
Advertisement
