Safety Decals; Figure 6: Hydraulic Cylinder Support In Place - Toro MH-400 Operator's Manual

MH-400. If problems result, this may violate local
regulations, void the warranty, or cause injury or death.
: Install the hydraulic cylinder
W
ARNING
supports before doing any maintenance
work under the hopper (Figure 6).

Figure 6: Hydraulic cylinder support in place

Page 12

Safety Decals

Important safety decals on your MH-400 indicate areas
with potential safety hazards. Replace any decal that
becomes lost, damaged, or illegible.
119-6806: Consult Operator's Manual
Get appropriate training before operating
Projectile hazard stay a safe distance from the machine
No maintenance while machine is in use
No passengers
Do not operate with guards removed
119-6844: Shear hazard
Avoid rotating shaft
119-6805: Shear hazard
Avoid rotating spinner disks
119-6812: Tip over hazards
Do not turn sharp when going fast
Do not drive MH-400 on steep slopes
Slow down and turn gradually
Do not exceed 15 mph (24 km/h)
Drive slowly over uneven surfaces or when carrying a
full or heavy load
Setup Instructions