Advertisement
Description
Washer-fluid tank
Tank-support bracket (216 x 95 mm (8-1/2 x
3-3/4) with 90° flange)
Carriage bolt (5/16 x 3/4 inch)
Flanged locknut (5/16 inch)
Hose (3/16 inch)
Barbed hose connector
Wire harness
Push fastener
Cable tie
Preparing the Machine
1. Park the machine on a level surface and set the parking
brake.
2. Raise the hood; refer to your Operator's Manual.
3. Raise the cargo box; refer to your Operator's Manual.
4. Shut off the engine and remove the key.
5. Disconnect the negative-battery cable; refer to your
Operator's Manual.
Qty.
1
1
2
2
Install the windshield washer fluid kit (MD-series models).
1
1
1
3
1
Installing the Windshield
Washer Fluid Kit
For GTX-Series Models
Installing the Washer-Fluid Tank
For Machines with the Storage Box Kit Installed
If you have the Storage Box Kit installed, discard the
washer-fluid-tank bracket.
1. Install the washer-fluid tank to the storage box with the
4 carriage bolts (5/16 x 3/4 inch) and 4 flange nuts
(5/16 inch) as shown in
1. Storage box
2. Carriage bolt (5/16 x 3/4
inch)
2. Torque the flange nuts to 1,987 to 2,542 N∙cm (175
to 225 in-lb).
2
Use
Figure
1.
Figure 1
3. Flange nut (5/16 inch)
4. Washer-fluid tank
Advertisement
