Advertisement
Operation
Using the Windshield Washer
Using the Wiper/Washer Control
•
Push the wiper/washer switch up to run the windshield
wipers
(Figure
52).
Figure 52
1. Wiper On
2. Washer On (momentary)
3. Wiper Off
•
Push the wiper/washer switch down to stop the
windshield wipers
(Figure
•
Momentarily push in the upper half of the wiper/washer
switch to spray the washer fluid onto the windshield
(Figure
52).
Filling the Washer Tank
1. Access the washer tank as follows:
•
For HD-series Workman machines, raise the cargo
bed and place the safety support on the lift cylinder;
refer to your Operator's Manual.
•
For GTX-series and MD-series Workman
machines, raise the hood; refer to your Operator's
Manual.
2. Remove the cap from the washer tank
4. Wiper/washer switch
5. Overhead console
52).
(Figure
53).
1. Cap
2. Filler neck (washer tank)
3. Add water or windshield-washer fluid through the filler
neck of the tank to within 25 mm (1 inch) of the top of
the tank
(Figure
Note: In climates where freezing temperatures occur,
use all season (ethanol type) windshield-washer fluid.
4. Install the cap onto the filler neck securely
5. Prepare the machine for operation as follows:
•
HD-series Workman machines— Remove the
safety support from the bed lift cylinder, stow the
safety support, and lower the bed; refer to your
Operator's Manual.
•
GTX-series and MD-series Workman
machines—Lower the hood and secure it with the
hood latches; refer to your Operator's Manual.
19
Figure 53
3. 25 mm (1 inch) fill level
4. Water or
windshield-washer fluid
53).
(Figure
53).
Advertisement
