Advertisement
Installing the Windshield
Washer Fluid Kit
For HD-Series Models
Removing the Roof Panel
Roof panel weight: 9.5 kg (21 lb)
1. Remove the 10 bolts (1/4 x 1 inch) and 10 sealing
washers (1/4 inch) that secure the roof panel to the
roof-support brackets of the cab
Note: Retain the bolts and washers for installation of
the roof panel in
Installing the Overhead Console Plug
and the Roof Panel (page
1. Bolt (1/4 x 1 inch)
2. Sealing washer (1/4 inch)
2. Lift the roof panel straight up and remove it from the
cab of the machine.
Note: Be careful when you set the roof panel down to
avoid damaging the surface and edges of the panel.
3. Remove the plug from the overhead console
14).
(Figure
13).
11).
Figure 13
3. Roof-support bracket
4. Roof panel
1. Overhead console
Installing the Washer-Fluid Tank
1. Assemble the washer-fluid tank to the tank-support
bracket with the 2 carriage bolts (5/16 x 3/4 inch) and
2 flanged locknuts (5/16 inch) as shown in
1. Carriage bolt (5/16 x 3/4
inch)
2. Hole—square (tank
(Figure
support bracket for
HD-series models—221 x
168 mm (8-11/16 x 6-5/8
inch) with 45° flange)
2. Torque the flanged locknuts to 1,987 to 2,542 N∙cm
(175 to 225 in-lb).
3. Locate the 2 holes 6.3 mm (1/4 inch) at the center of
the rear panel of the cab
Note: The holes are spaced apart 178 mm (7 inches).
6
Figure 14
2. Plug
Figure
Figure 15
3. Hole (washer fluid tank)
4. Flanged-locknut (5/16
inch)
(Figure
16).
15.
Advertisement
