Advertisement
Securing the Wire Harness
1. Remove the 2 harness clips that secure the cab wire
harness to the front, left cab frame
Figure 48
1. Harness clips
2. Install 2 push fasteners at the location where you
removed the harness clips in step
Figure
49).
Figure 49
1. Push fastener
3. Secure the cab harness, washer-pump harness, and
hose with the cable tie portion of the push fasteners
(Figure
49).
Note: Tighten the cable tie only snug. Do not pinch
or collapse the hose.
4. Remove the harness clip that secures the cab wire
harness to the lower forward-cab panel at the driver's
side of the machine
(Figure
48).
2. Cab frame
1 (Figure 48
2. Hole (cab frame)
(Figure
50).
and
1. Harness clip
2. Hose
3. Hole (lower, forward cab
panel)
5. Install a push fastener at the location where you
removed the harness clip in step
6. Secure the cab harness, washer-pump harness, and
hose with the cable tie portion of the push fastener
(Figure
7. Coil the excess washer-pump harness
secure the coiled harness and hose with a cable tie.
1. Electrical mounting plate
2. Hose
3. Cable tie
17
Figure 50
4. Wire harnesses (cab
harness and washer-pump
harness)
5. Push fastener
4 (Figure
50).
Figure 51
4. Washer-pump harness
(coiled)
5. Fender
50).
(Figure
51), and
Advertisement
