Advertisement
Figure 6
1. Frame channel
2. Floor-channel plate
5. Route the kit hose through the opening in the top of
the frame channel
(Figure
Figure 7
1. Frame channel
6. Secure the kit hose along the frame channel and as
necessary.
7. Connect the kit to the pump; refer to
Hose to the Pump (page
3. Kit hose
7).
2. Kit hose
Connecting the
4).
Connecting the Hose to the Pump
1. At the washer-fluid tank, align the end of the hose to
the barbed fitting in the washer pump
1. Hose
2. Barbed fitting
2. Push the hose onto the fitting until the hose fully seats
onto the fitting
(Figure
Note: If the hose is too long, shorten it.
Routing and Connecting the Kit Wire
Harness to the Cab Wire Harness
1. Connect the male connector on the kit wire harness to
the female connector on the cab wire harness
9).
1. Cab wire harness
2. Female connector
2. Route the kit wire harness along the floor-channel plate
and through the opening in frame channel
4
(Figure
Figure 8
3. Washer-pump motor
8).
Figure 9
3. Male connector
4. Kit wire harness
(Figure
8).
(Figure
10).
Advertisement
