Operating Magicstream Laminars In Standard Mode - Pentair MAGICSTREAM LAMINAR Installation And User Manual

8
Operating MagicStream ® Laminars in Standard Mode
To access the Standard Mode setting, you must cycle the power to the MagicStream ®
Laminar with 16 Off/On sequences. To return to the IntelliBrite Mode, cycle the power Off/
On with 17 sequences. When in Standard Mode, turning the switch Off and On a specific
number of times, the light activates one of the three light show modes or locks a chosen
color.
Selecting a color light show mode or fixed color
Switch power on to the MagicStream laminar. A random color will flash indicating the
program you are in, followed by the previously selected program mode. To select a color
show mode or fixed color, turn the wall switch off/on a specific number of times. Please
review the chart below and follow the power cycle sequence to activate the various show
feature effects while in "show" modes.
1. Fixed Color: Turn power off and then on to "Hold" the Light on that specific color (no
matter what color show you are in). If you keep the unit on that color for at least five (5)
seconds, the MagicStream laminar will "save" this color and keep it in that mode until you
release it with an additional power off/on sequence. In "Fixed Color" mode the light when
powered on, will not flash its program, but immediately go to the "Fixed Color" chosen.
2. Color Show Mode: Turn power off and then on twice (Off/On, Off/On) to cycle through
the following three color modes. Turning the power on and off twice (Off/On, Off/On) will
continue to cycle through the programs.
Synchronized Mode: All MagicStream laminars on the same circuit will synchronize
and cycle on the same colors. When the units are in this mode, when powered up,
the light will flash a random color one time and then turn all units on white and then
start cycling through the eight colors. The single flash of a random color is the visual
confirmation what color show you have activated. The light will stay in this mode each
time the system is powered on until a program change is made. Colors will change at 10
sec intervals.
Random Mode: Turn the power on and then off twice (Off/On, Off/On) and the light
will cycle to the next program, Random Mode. In this mode each of the MagicStream
laminars will cycle together, but in random colors. When this mode is selected, the light
will flash twice to indicate it is in random mode and then start up in a random color
sequence. If multiple lights are on the same circuit, each light will display different
random colors. Colors will change at about 10 sec intervals but in a completely random
sequence. In this mode, multiple Laminars will NOT change colors together.
Party Mode: Turn the power on and then off twice (Off/On, Off/On) and the light will
cycle to the next program, Party Mode. In this mode each of the MagicStream laminars
will cycle together, but in random colors and in ever increasing cycle speeds until the
last ten seconds at which time the MagicStream laminars will randomly flash different
colors at different times. When this mode is selected, the light will flash three times to
indicate it is in Party Mode and then start up in a random color sequence. If multiple
lights are on the same circuit, each light will display different colors. Colors will change
randomly and slowly at first, then speed up, until the sequence ends with quick flashes
and strobes. The sequence then repeats, beginning with the slow changes. In this mode,
multiple laminars will NOT change color together.
MAGICSTREAM ® Laminar Installation and User's Guide