Pentair MAGICSTREAM LAMINAR Installation And User Manual page 9

Example: To select California Sunset Mode;
previously selected color show mode or fixed color is displayed, then rapidly turn the switch
off and on six (6) successive times. During the Off/On switching process, no illumination
will occur.
Which Mode the Light is in?
IntelliBrite Mode, fixed on white, Random Mode off and Thumper on.
From there you can set the desired mode. See page 6.
Random Mode
The MagicStream
will randomly transition through the same color palette as in IntelliBrite Mode at a similar
speed to the IntelliBrite Mode. As an example, lights in American Mode display a pattern
of red, white and blue, while lights in IntelliBrite Random Mode and American Mode will
display the same colors, but each light will display them in a random order. The speed of
the transitions is also tied to the IntelliBrite Mode. Sam Mode will change colors slowly
and Party Mode will change more rapidly.
Activating IntelliBrite Random Mode: To toggle IntelliBrite Random Mode On or Off
you need to enter Party Mode(Off-On-Off-On), wait until the lights come on and then enter
Party Mode a second time (Off-On-Off-On) with less than 30 seconds between them (Off-
On-Off-On) (Wait for light to come on) (Off-On-Off-On) (Wait for light to come on).
Solenoid Thumper
The solenoid thumper feature creates a "wrinkle" in the laminar stream creating a brilliant
spot of light in the laminar arc. Toggle the Thumper On or Off by entering Party Mode 3
times in less than 30 seconds...
(Off-On-Off-On) (Wait for light to come on) (Off-On-Off-On) (Wait for light to come on)
(Off-On-Off-On) (Wait for light to come on)
All modes, except random, thump every 4 seconds except for Party Mode which thumps
every 2 seconds. Random Mode thumps randomly every 1 to 3.5 seconds.
Resetting All Lights: To Reset all the lights you need to enter Party Mode four (4) times
with less than 30 seconds between them. This will turn IntelliBrite Random Mode OFF.
This is needed because should two lights ever get into different states, toggling their
states will never fix the problem (Off-On-Off-On) (Wait for light to come on) (Off-On-Off-
On) (Wait for light to come on) (Off-On-Off-On) (Wait for light to come on) (Off-On-Off-On)
(Wait for light to come on).
Saving a color mode or fixed color
When power is switched off to the MagicStream laminars, the last color show mode or
fixed color will be saved. The next time the light is powered on, the previously saved color
show mode or fixed color will be displayed. For example, while in Party Mode switch the
light off. Wait more than 10 seconds, switch the light back on to resume Party Mode.
Note: For more information about setting up and operating the MagicStream Laminar, see
page 23.
Turn the switch Off/On 17 times to reset the light to
® Laminar has an additional Random Mode. In Random Mode the lights
First switch power on to the light; the
MAGICSTREAM ® Laminar Installation and User's Guide
7