Light Enhancer Adjustment - Pentair MAGICSTREAM LAMINAR Installation And User Manual

25
Light Enhancer Setup (darkness required)
You may want to vary the intensity of the light when using the LED to light
the laminar stream. You can adjust the light intensity by means of the light
enhancer. The light enhancer uses a very small stream of water to add very
small bubbles to the stream. The screw that controls the light enhancer is
located on the laminar orifice plate (Figure 6).
There is no optimal setting for the light enhancer, and the intensity of the light
emitting from the laminar stream is purely a matter of taste. We encourage
you to experiment with the light enhancer to achieve the effect you desire.
NOTE: Laminars are sensitive to wind, earth movement and equipment
vibration. Secure the laminar and deck housing to minimize vibration.
Periodic stream distortion, caused by pump vibrations and motor electrical
fluctuations, is normal and not indicative of a nozzle defect.
NOTE: A laminar may occasionally "burp" as a result of trapped air
accumulating in the nozzle body. This phenomenon is normal and will occur
until all air is purged from the piping system. Trapped air can also cause
slight distortion in water action. It is imperative that all air is removed to
ensure proper water feature operation.
Control screw
Light enhancer
Figure 6
MAGICSTREAM ® Laminar Installation and User's Guide