Replacing Magicstream Laminar Assembly (In An Existing Pool And Spa) - Pentair MAGICSTREAM LAMINAR Installation And User Manual

14
REPLACING THE MAGICSTREAM
Verify that the pool and spa meets the requirements of the current National
Electrical Code and all local codes and ordinances. A licensed or certified
electrician must install the electrical system to meet or exceed those
requirements before the underwater light is installed. Some of the requirements
of the National Electrical Code which the pool's electrical system must meet are
as follows:
voltage models, and has an appropriately rated circuit breaker.
inches (20.3 cm) above ground level and at least 48 inches (1.219 m) from
the edge of the pool.
requirements, the electrician should also consult the local building
department.
MAGICSTREAM ® Laminar Installation and User's Guide
(IN AN EXISTING POOL OR SPA)
Risk of Electrical Shock or Electrocution!
This light must be installed by a licensed or certified electrician
or a qualified pool professional in accordance with the current
National Electrical Code (NEC), NFPA 70 or the Canadian
Electrical Code (CEC), CSA C22.1 and all applicable local codes
and ordinances. Improper installation will create an electrical
hazard which could result in death or serious injury to pool
users, installers or others due to electrical shock, and may also
cause damage to property.
Always disconnect the power to the pool light at the circuit
breaker before servicing the light. Failure to do so could result in
death or serious injury to serviceman, pool users or others due
to electrical shock.
®
LAMINAR ASSEMBLY