Pentair MAGICSTREAM LAMINAR Installation And User Manual page 17

REPLACING THE MAGICSTREAM
(AFTER ELECTRICAL REQUIREMENTS ARE MET)
The following removal and installation instructions describe how to remove and install the
®
MagicStream Laminar assembly. Also use these instructions after completing the following
light replacement procedure.
Failure to bring the pool or spa's electrical system up to code requirements
before installing the light will create an electrical hazard which could result
in death or serious injury to pool users, installers, or others due to electrical
shock, and may also cause damage to property.
1. Switch off electrical switch or circuit breaker at the source.
2. Remove Junction Box or Transformer cover. Disconnect the light wires and
attach a fish tape to the existing light power cord. This will assist in pulling
the replacement light power cord through the conduit back to the junction
box.
3. Remove the MagicStream laminar assembly from the housing.
4. Slowly pull the light and attached power cord (with attached fish tape) out of
the housing. Pull the light's power cord and fish tape out of the housing and
place the light on the deck.
5. Attach the new light power cord to the fish tape and carefully feed the fish
tape and cable to the junction box.
6. Feed cord through housing then through conduit to Junction Box or 12 Volt
AC Transformer. The MagicStream laminar has no serviceable parts, so
leave approximately 3 to 4 feet of cord to allow the light to be easily removed
if replacement is required.
7. Cut the cord at the Junction Box or 12 volt AC transformer, leaving at least
six (6) inches of cord to make connections.
8. Strip back three (3) inches of the outer cord jacket to expose the two
insulated wires (be careful not to damage the insulation on the two (2) inner
wires).
9. Connect both (2) wires to the corresponding circuit wires in the Junction Box
or 12 Volt AC Transformer and secure the Junction Box cover in place.
10. Install the MagicStream laminar assembly into the niche and tighten the two
screws provided.
®
LAMINAR ASSEMBLY
MAGICSTREAM ® Laminar Installation and User's Guide
15