Magicstream Laminars Overview; Operating Modes (Standard And Intellibrite) - Pentair MAGICSTREAM LAMINAR Installation And User Manual

4
MagicStream
This manual describes how to install and replace the MagicStream
MagicStream laminar provides brilliant vivid multi-colors with spectacular lighting effects
for your pool and spa. The energy efficient colored LED array utilizes IntelliBrite
LED Light technology and can cycle through colors at varying speeds and in different
sequences of colors. Choose one of the seven pre-programmed color light shows or select
one of the five fixed colors to create virtually endless range of dramatic underwater lighting
effects for a spectacular effect in your pool and spa.
The LED Light Engine controls the operation of the following features, and its built-
in memory capability ensures that each time you turn the light engine on, it resumes
operation with the same features in operation as when you last turned it off:
If multiple types of IntelliBrite LED lights are being used, all lights connected to the same
transformer will be working together.
Note: For more information about setting up and operating the MagicStream Laminar, see
page 23.

Operating Modes (Standard and IntelliBrite)

There are two operating settings built-in the MagicStream laminar, Standard Mode and
IntelliBrite Mode. The default factory setting is IntelliBrite Mode. Use the Standard
Mode setting if you wish to be compatible with legacy laminars without IntelliBrite Mode
capability. If there is a MagicStream laminar model installed in your pool or spa that does
not support the IntelliBrite Mode feature, reset the MagicStream laminar to Standard Mode
to match the existing set up, see page 8. To access the Standard Mode setting, you must
cycle the power to the MagicStream laminar with 16 off/on sequences. To return to the
IntelliBrite Mode setting, cycle the power 17
off/on sequences.
Operating MagicStream
The MagicStream laminar can be controlled using a standard wall-mount light switch.
Multiple MagicStream laminars can be connected via a junction box to a single switch so
that all lights can be switched on and off together. The lights are controlled by cycling the
AC power to the power supply and from there to the lights from a standard wall switch. By
turning the switch OFF and ON a specific number of times, the light activates one of the
seven light show modes, fixed colors, or enables the "Hold" and "Recall" feature.
Note: Wall switch must be connected to the 120 VAC side of the transformer and
never to the 12 VAC side.
Operating MagicStream
MagicStream laminar
®
EasyTouch Control Systems, utilizing the IntelliBrite "Circuit Function". For more
information refer to the IntelliTouch Control System User's Guide (P/N 521075),
EasyTouch Control System User's Guide (P/N 521044).
For more information, see page 16.
MAGICSTREAM ® Laminar Installation and User's Guide
®
Laminar Overview
®
Laminars Using a Wall Switch
® Laminars Using Automation Control System
can also be automatically controlled via Pentair IntelliTouch
®
Laminar. The
® Color
®
and