HP 53150A Series Programming Manual page 46

NOTE
1
2
3
4
NOTE
Chapter 3 Programming Your Counter for Remote Operation
Connecting the Counter to a Computer
The following section, titled "Changing the HP-IB Address," provides
instructions for setting the HP-IB address from the Counter's front panel.
Once the Counter is in Remote mode, all front-panel keys except the
Reset/Local key are disabled. As long as local-lockout is off, pressing the
Reset/Local key returns the counter to Local mode.
Changing the HP-IB Address
Press and release the Shift key, and then press HPIB (Resol). The HPIB
ADDR menu is displayed, the current HP-IB address is shown to the right
of the blinking indicator (>), and the LED indicator between the arrow
keys flashes.
Press the right-arrow key. The blinking indicator changes direction (from
> to <), and the current HP-IB address blinks.
Press (or press and hold) the up-arrow or down-arrow key to change the
HP-IB address (the available addresses are 1 to 30).
When your desired address is displayed, press the Enter key. The address
you selected is assigned, and the display returns to its normal operating
mode. You must press the Enter key to complete the entry.
To configure the Counter so that the a specific HP-IB address is
automatically assigned each time you turn the Counter on, select the
address, and then save your current settings in SAV 0. The settings in
SAV 0 are recalled each time the Counter is turned on.
IEEE 488.1 Interface Capabilities
The HP 53150A/151A/152A Counter has the following IEEE 488.1
:
Interface capabilities
SH1
AH1
T6
L3
3-6
SR1 DT1
RL1 C0
PP1 E1
DC1
Programming Guide