HP 53150A Series Programming Manual page 139

Chapter 4 Command Reference
:SYSTem Subsystem
:SYSTem Subsystem
This subsystem collects together the capabilities that are not related to
instrument performance.
:SYSTem:COMMunicate Subtree
The :SYSTem:COMMunicate subtree collects together the configuration of
the control/communication interfaces.
The :SYSTem:COMMunicate:SERial subtree controls the physical
configuration of the RS-232C port. Any command to change the settings
takes effect immediately upon receipt of the "program message
termination." These settings are stored in non-volatile memory, and are
unaffected by power-on, *SAV/*RCL, and *RST.
The :SYSTem:COMMunicate:SERial:TRANsmit subtree controls
parameters associated with transmission.
The Counter always uses eight data bits, one stop bit, and no parity.
:SYSTem:COMMunicate:GPIB[:SELF]:ADDress . . . <numeric_value>
COMMAND
Sets the HP-IB address that the Counter uses.
<NR1>
REPLY FORMAT
• The range for <numeric_value> is 0 through 30.
COMMENTS
• The default setting is address 19.
• This value is unaffected by *RST.
• To change the HP-IB address used at power-on, save the instrument
settings using the *SAV 0 command after changing the HP-IB
address.
Shift + HPIB
RELATED
FRONT-PANEL
KEYS
Programming Guide 4-39