HP 53150A Series Programming Manual page 34

Chapter 2 Command Summary
HP 53150A/151A/152A Command Summary
Table 2-2. HP 53150A/151A/152A SCPI Command Summary (Continued)
Keyword/Syntax
Measurement Instructions
:CONFigure[:SCALar]:<function>
:CONFigure?
:MEASure:[:SCALar]:<function>?
:READ[:SCALar]:<function>?
:FETCh[:SCALar]:<function>?
*The <function> and corresponding <parameters> and <source_list> are defined below:
<function>
[:VOLTage]:FREQuency
:POWer[:AC]
___________________________________
*<source_list> has the same syntax as SCPI <channel_list>. For example, a frequency
measurement on channel 2 uses (@2) to specify channel 2.
2-14
Parameter Form Std/New
See <parameters>
and <source_list>
below.
See <parameters>
and <source_list>
below.
<parameters> [,<source_list>]*
[<expected_value>[,< [,(@1) | (@2)]
resolution>]] [,(@2)]
[<expected_value>[,<
resolution>]]
Comments
Std Configures the
instrument to perform the
specified measurement.
Std Returns the function
configured by the last
:CONFigure or
:MEASure command.
Std Configures the
instrument, initiates
measurement, and
queries for the result
(i.e., provides a complete
measurement sequence.
Std Initiates measurement,
and queries for the
result. (Performs a
:FETCh? on "fresh"
data.)
Std Queries the
measurement made by a
previous :MEASure,
:READ, or :INITiate
command.
Std/New
Std
Std
Programming Guide