HP 53150A Series Programming Manual page 131

Chapter 4 Command Reference
:STATus Subsystem
:STATus Subsystem
The :STATus subsystem commands allow you to specify or examine the
status of the Operation Status Register group and the Questionable
Data/Signal Register group.
:STATus:OPERation Subtree
The :STATus:OPERation subtree commands allow you to examine the
status of the Counter monitored by the Operation Status Register Group,
shown in Figure 4-1. The Operation Status Register Group consists of a
condition register, two transition registers, an event register, and an
enable register. The commands in this subtree allow you to control and
monitor these registers.
See the sections titled "Operation Status Register Group" and
"Questionable Data Status Register Group" on pages 3-37 and 3-39 for a
detailed description of the Operation Status Register Group.
Waiting for Trigger
Using Internal Reference
Figure 4-1. The Operation Status Register Group
Programming Guide
Bits
( 1 )
Calibrating
0
Not Used
0 to 3
( 16 )
Measuring 4
(32)
5
Not Used
6 to 8
( 512 )
9
( 1024 )
Not Used
10
( 2048 )
Acquiring
11
( 4096 )
Locked
12
Not Used 13 to 15
4-31