HP 53150A Series Programming Manual page 132

Chapter 4 Command Reference
:STATus Subsystem
:STATus:OPERation:CONDition?
COMMAND
Queries the status of the Operation Condition Status Register.
•
QUERY RESPONSE
•
•
•
COMMENTS
•
•
None
RELATED
FRONT-PANEL
KEYS
:STATus:OPERation:ENABle <non-decimal numeric> | <NRf>
COMMAND
Sets or queries the Operation Event Status Enable Register.
The range for the <non-decimal numeric> or <NRf> parameter is
RANGE
0 to 32,767.
Numeric data transferred as ASCII bytes in <NR1> format.
QUERY RESPONSE
•
COMMENTS
•
•
•
•
None
RELATED
FRONT-PANEL
KEYS
4-32
Numeric data transferred as ASCII bytes in <NR1> format.
Range is 0 to 32,767.
The query response value is an integer formed by the binary
weighting of the bits. The value of unused bits is zero.
Query only.
The Operation Condition Status Register is cleared at power-on.
Bits are not cleared when read.
The parameter and query response value, when rounded to an integer
value and expressed in base 2 (binary), represent the bit values of the
Operation Event Status Enable Register.
The value of unused bits is zero when queried and is ignored when set.
This register is used to enable a single or inclusive OR group of
Operation Event Status Register events to be summarized in the
Status Byte Register (bit 7).
At power-on and :STAT:PRES, the Operation Event Status Enable
Register is cleared (value is 0).
This value is unaffected by *RST and *SAV/*RCL.
Programming Guide