HP 53150A Series Programming Manual page 125

Chapter 4 Command Reference
[:SENSe] Subsystem
[:SENSe]:FREQuency:OFFSet . . . <numeric_value>[<frequency unit>]
COMMAND
Sets a reference frequency for all other absolute frequency settings in the
instrument.
The acceptable range for the <numeric_value> parameter is 0 to 50 GHz.
RANGE
The offset frequency can be specified in Hz, KHz, or MHz only.
UNITS
• This command does not affect the hardware settings of the
COMMENTS
instrument. It affects only the entered and displayed frequencies.
• The Counter accepts only six digits of resolution for an offset entry
through this command. For example, the command
FREQ:OFFSet 12345.678912MHz results in an offset of
approximately 12.3456 GHz.
• The coupling equation for this command is:
Entered | Displayed frequency = (Hardware frequency ) + offset.
Freq Offset
RELATED
FRONT-PANEL
KEYS
[:SENSe]:FREQuency:OFFSet:STATe . . . <Boolean>
COMMAND
When FREQuency:OFFSet is ON, the frequency measurement results are
modified by the setting of FREQ:OFFset before being displayed or
reported (in response to a query).
Freq Offset
RELATED
FRONT-PANEL
KEYS
Programming Guide 4-25