HP 53150A Series Programming Manual page 137

Chapter 4 Command Reference
:STATus Subsystem
None
RELATED
FRONT-PANEL
KEYS
:STATus:QUEStionable:ENABle . . . <non-decimal_numeric> | <NRf>
COMMAND
Sets or queries the Questionable Data Event Status Enable Register.
The range of the <non-decimal numeric> or <NRf> parameter is
RANGE
0 to 32,767.
Numeric data transferred as ASCII bytes in <NR1> format.
QUERY RESPONSE
•
COMMENTS
•
•
•
•
None
RELATED
FRONT-PANEL
KEYS
:STATus:QUEStionable[:EVENt]?
COMMAND
Queries the status of the Questionable Data Event Status Register.
•
QUERY RESPONSE
•
•
•
COMMENTS
Programming Guide
The parameter and the query response value, when rounded to an
integer value and expressed in base 2 (binary), represent the bit
values of the Questionable Data Event Status Enable Register.
The value of unused bits is zero when queried and ignored when set.
This register is used to enable a single or inclusive OR group of
Questionable Data Event Status Register events to be summarized in
the Status Byte Register (bit 3).
At power-on and :STAT:PRES, the Questionable Data Event Status
Enable Register is cleared (value is 0).
This value is unaffected by *RST, *CLS, and *SAV/*RCL.
Numeric data transferred as ASCII bytes in <NR1> format.
Range is 0 to 32,767.
The query response value is an integer formed by the binary
weighting of bits. The value of unused bits is zero.
Each event bit in the Questionable Data Event Status Register
corresponds to a specific condition bit in the Questionable Data
4-37