Removing the Reel Drive Belt (continued)
Installing the Reel Drive Belt
Traction and Reel Drive Systems: Service and Repairs
3. Remove and inspect the reel drive gasket (5) from the reel drive assembly
(1). Discard the reel drive gasket (5), if damaged.
4. Loosen the bolt (4) and rotate the idler arm (3) to release the tension on
the reel drive belt (2).
5. Remove the reel drive belt (2) from the pulleys.
1. Ensure that the bolt (4) is loose enough to move the idler arm (3) freely.
2. Place the new drive belt (2) onto the pulleys.
3. Adjust the reel belt tension; refer to
4. Ensure that the reel drive gasket (5) is in position and install the reel drive
cover (6) to the reel drive assembly (1) and secure with the 3 socket head
screws (7).
5. Torque tighten the socket head screws to 1.7 to 4.5 N∙m (15 to 40 in-lb).
Use an alternation pattern and torque tighten the socket head screws to 9.6
to 10.7 N∙m (85 to 95 in-lb).
6. Attach the spark plug wire to the spark plug.
Adjusting the Reel Drive Belt (page
Page 5–6
5–3).
Greensmaster
®
1018/1021/1026
18238SL Rev B