Toro Greensmaster 1018 Service Manual page 177

Disassembling the Height Adjuster (continued)
Assembling the Height Adjuster
Greensmaster ® 1018/1021/1026
18238SL Rev B
4. Remove the hex nuts and plow bolts that secure the height-of-cut brackets
to the cutting unit side plates, and remove the height adjusters and front
roller from the cutting unit.
5. Disassemble the height adjuster assembly as necessary.
6. Replace components that are worn or damaged.
1. Apply anti-seize lubricant to the upper threads of the adjustment rod and
lower threads of the height adjusters. Assemble the height adjuster assembly.
2. If both the height adjusters are removed, fit 1 height adjuster assembly to the
cutting unit side plate and secure it with a plow bolt, tabbed washer and lock
nut. Tighten the lock nut finger tight.
3. Position front roller between the height adjuster assemblies and secure the
remaining height adjuster assembly to the cutting unit side plate with a plow
bolt and lock nut. Tighten the lock nut finger tight.
4. Center the front roller between the height-of-cut brackets and tighten the
front roller pinch bolts.
5. Install new cotter pins and clevis pins and secure the height adjustment rods
to the groomer gear box and idler arm.
6. Adjust the cutting unit height-of-cut; refer to Cutting Unit Operators Manual.
7. Check the groomer reel height and adjust as necessary.
g282213
8. Adjust the flange nuts on the groomer height adjustment rods until the
springs are compressed to 19 mm (0.75 inch).
Figure 92
Page 9–15 Universal Groomer (Optional): Service and Repairs