Variable definitions
Use the data in the following table to use the boot config flags command.
access-service
Enabling the Web server for EDM access
Enable the Web server to provide management access to the switch using Enterprise Device
Manager.
Prerequisites
You must log on to the Global Configuration mode in the ACLI.
Procedure steps
1. Enable the Web server by using the following command:
2. Configure the access password by using the following command:
Commissioning
Variable
web-server enable
web-server password <rwa> <username> <passwd>
Enabling the Web server for EDM access
Value
Specifies one of the following remote-access
service types to enable:
• ftpd
• rlogind
• sshd
• telnetd
• tftpd
Use the no operator to remove this
configuration. To configure this option to the
default value, use the default operator with
the command.
June 2011
99