Specifying The Primary Sf/Cpu - Avaya 8800 Commissioning Manual

Initial steps using the ACLI
clock set <MMddyyyyhhmmss> MMddyyyyhhmmss

Specifying the primary SF/CPU

Specify the primary SF/CPU to determine which SF/CPU you use as the master after the switch
performs a full power cycle only. When the SF/CPU becomes the primary, the master LED for
the SF/CPU is on.
Prerequisites
• You must log on to at least Privileged EXEC mode to use the show command.
• You must log on to the Global Configuration mode in the ACLI to use the configuration
command in this procedure.
Procedure steps
1. View the current setting for the primary SF/CPU by using the following command:
2. Specify the slot of the primary SF/CPU by using the following command:
3. Save the configuration to the boot.cfg and pcmboot.cfg files.
4. Restart the switch.
Variable definitions
Use the data in the following table to use the boot config master command.
<cpu-slot>
68 Commissioning
show boot config master
boot config master <cpu-slot>
Variable Value
Specifies the slot number for the primary SF/
CPU. This variable can be 5 or 6. The default
primary is slot 5.
June 2011