Chapter 5 - Data Formatting; Data Format Editor Introduction - Honeywell N3680 User Manual

CHAPTER
5
DATA FORMATTING

Data Format Editor Introduction

You may use the Data Format Editor to change the scan engine's output. For exam-
ple, you can use the Data Format Editor to insert characters at certain points in bar
code data as it is scanned. The selections in the following pages are used only if
you wish to alter the output. Default Data Format setting = None.
Normally, when you scan a bar code, it is output automatically. However, when you
create a format, you must use a "send" command (see
64) within the format program to output data.
Multiple formats may be programmed into the scan engine. They are stacked in the
order in which they are entered. However, the following list presents the order in
which formats are applied:
1. Specific Terminal ID, Actual Code ID, Actual Length
2. Specific Terminal ID, Actual Code ID, Universal Length
3. Specific Terminal ID, Universal Code ID, Actual Length
4. Specific Terminal ID, Universal Code ID, Universal Length
5. Universal Terminal ID, Actual Code ID, Actual Length
6. Universal Terminal ID, Actual Code ID, Universal Length
7. Universal Terminal ID, Universal Code ID, Actual Length
8. Universal Terminal ID, Universal Code ID, Universal Length
The maximum size of a data format configuration is 2000 bytes, which includes
header information.
If a bar code is read that fails the first data format, the next data format, if there is
one, will be used on the bar code data. If there is no other data format, the raw data
is output.
N3680 Decoded Engine User Guide
Send Commands on page
61