Menu Bar Code Security Settings; Set Custom Defaults - Honeywell N3680 User Manual

The aiming beam is smaller when the scan engine is closer to the code and larger
when it is farther from the code. Symbologies with smaller bars or elements (mil
size) should be read closer to the unit. Symbologies with larger bars or elements
(mil size) should be read farther from the unit. To read single or multiple symbols
(on a page or on an object), hold the scan engine at an appropriate distance from
the target, pull the trigger, and center the aiming beam on the symbol. If the code
being scanned is highly reflective (e.g., laminated), it may be necessary to tilt the
code up 15° to 18° to prevent unwanted reflection.

Menu Bar Code Security Settings

Honeywell scan engines are programmed by scanning menu bar codes or by send-
ing serial commands to the scan engine. If you want to restrict the ability to scan
menu codes, you can use the Menu Bar Code Security settings. Contact your Hon-
eywell OEM representative for more information.

Set Custom Defaults

You have the ability to create a set of menu commands as your own, custom
defaults. To do so, scan the Set Custom Defaults bar code below before scanning
the menu commands for your custom defaults. If a menu command requires scan-
ning numeric codes from the back cover, then a Save code, that entire sequence
will be saved to your custom defaults. When you have entered all the commands
you want to save for your custom defaults, scan the Save Custom Defaults bar
code.
You may have a series of custom settings and want to correct a single setting. To do
so, just scan the new setting to overwrite the old one. For example, if you had previ-
ously saved the setting for Beeper Volume at Low to your custom defaults, and
decide you want the beeper volume set to High, just scan the Set Custom Defaults
bar code, then scan the Beeper Volume High menu code, and then Save Custom
Defaults. The rest of the custom defaults will remain, but the beeper volume set-
ting will be updated.
N3680 Decoded Engine User Guide
Set Custom Defaults
Save Custom Defaults
5