Table of Contents
Advertisement
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scan engine before
the picture is taken. Use these codes to set the time between when the trigger is
pulled and when the picture is taken. During the delay time, the aiming light will
appear, but the LEDs won't turn on until the delay time is over. Default = Off.
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the bar code
below, then set the time-out by scanning digits (0 - 4,000 ms) from the
Programming Chart
Aimer Mode
This feature allows you to turn the aimer on and off. When turning the aimer on,
there are 2 options: Interlaced (the aimer is interlaced with the illumination LEDs)
and Interlace Optimized for Decode (same as Interlaced except the aimer flashes
so that it is not captured in the image). N3680 Default = Interlaced. CF3680
default = Off.
Note: If y ou are having a hard time decoding using Interlaced, use Interlaced Optimized for
Decode.
N3680 Decoded Engine User Guide
200 milliseconds
* Off (no
inside the back cover of this manual, then scan Save.
Off
Delay Duration
400 milliseconds
45
Advertisement
Table of Contents
