Table of Contents
Advertisement
(4)
For values that include a decimal point, always input to the value below the decimal
point, because the decimal place is in a fixed position.
Example: To change a 000.0 setting to 123.0 in a 4-digit input.
Initial status
3
(5)
To redo a setting, press the [CNCL] key. The number input mode is canceled and the
initial value that was set is displayed and the entire item is highlighted.
(6)
After you have input the value, press the [ENT] key to set the value.
Precautions
You cannot set negative values by using this method. To do so,
use the [MULTI] knob or use the "Arrow" keys to do the setting.
Setting values with the arrow keys
(1)
You can increase or decrease the value of items with the [◀] and [▶] keys by moving to
a screen in which item values can be changed while a "Menu" is displayed.
Set the value that you want to set and press the [ENT] key or the [MULTI] knob to set
the value.
Example: When setting [CLUTTER].
The following shows how to change an initial value of 1 to 0.
Initial value = 1 changed to 0
Press the [◀] key one time to set the value to "0".
Press the [ENT] key or the [MULTI] knob to set it.
(2)
Each time a value is changed the screen reflects the change, depending on the
item. However, if you do not press the [ENT] key or the [MULTI] knob, the values
are not set.
3 Operating procedures
Display
[ENT] key
(set value)
000.0
[1]
000.1
[2]
001.2
[3]
012.3
[0]
123.0
3-22
Advertisement
Table of Contents
