Table of Contents
Advertisement
7.2.6.5
Tilt to Port Settings
Operating Procedure
settings
Example: If the starboard side is submerged 2.1°, turn the [MULTI] knob to set -2.1. Press the
[MULTI] knob to assign it.
The setting range is between
7.2.6.6
Display Angle Settings
Operating Procedure
settings
7
7 Other Items
Press the keys "9 → 1 → 6 → 5" to go to TILT TO PORT
In the [6. ADJUST] menu, turn the [MULTI] knob to
select "5. TILT TO PORT". Press the [MULTI] knob to
show the display for inputting values.
Input the angle at which the port and starboard sides
deviate horizontally while a hoisting device is
anchored.
-12.7°
and 12.7°, and is set in steps of 0.1.
Press the keys "9 → 1 → 6 → 6" to go to DISP ANGLE
In the [6. ADJUST] menu, turn the [MULTI] knob to
select "6. DISP ANGLE". Press the [MULTI] knob to
display the menu for inputting values.
Be sure to do this after executing "3. FURNISHED
ANGLE".
Example of settings values and confirmation method: If
a hoisting device is installed at central keel, and
propellers are attached to the center of the stern,
propeller noise is displayed, such as that in the
diagram to the left, when the ship moves. If there is
any deviation, input values into DISP ANGLE to adjust.
The setting range is between 0 and 359, and can be
set in steps of 1. As for how to do the settings, turn the
[MULTI] knob to open the menu for inputting values.
Turn the [MULTI] knob while looking at the image and
find the optimum position. Press the [MULTI] knob to
assign it.
7-24
Advertisement
Table of Contents
