Table of Contents
Advertisement
Selecting items with the cursor (trackball)
(1)
Press the [MENU] key to open the "Menu", and align the cursor with the item to select
to highlight the item. Press the [ENT] key to set the item.
(2)
To select a value or item that you want to select from a pull down list, use the
same procedure as in step (1) to select it and set it. The selected value is
shown in the item and the setting is reflected on the screen or the
transmitter/receiver unit.
(3)
Depending on the menu item, the setting is reflected on the screen if the
cursor is positioned on the menu item.
(4)
To change the item you have just set, move the cursor again. Because the
item is selected when the cursor highlights it, move the cursor to re-select the
item and press the [ENT] key.
(5)
If you do not move the cursor and press the [ENT] key, the item where the
cursor is located is set. You can select the same item again by pressing the
[MULTI] key without moving the cursor.
(6)
While the "Menu" is displayed, use the [MULTI] knob or the [▶] key or the [◀]
key to move a selection. Confirm that the item you want to set is selected.
(7)
Pressing the [MULTI] knob does the same operation as the [ENT] key.
3-17
3 Operating procedures
3
Advertisement
Table of Contents
