Table of Contents
Advertisement
Operating Procedure
settings
When the screen is finished being written, the message "WRITE OK" appears.
Precaution: Writing may not be possible, depending on the card. If this happens, contact your
retailer or service representative.
Press the keys "8 → 1 → 3 → 1" to go to WRITE FILE
Press the [MENU] key to open the menu.
Turn the [MULTI] knob to move to "OPERATION".
Press the [MULTI] knob to open the submenu.
Turn the [MULTI] knob to move to "MODE SET".
Press the [MULTI] knob to open the submenu.
Turn the [MULTI] knob to move to the "3. SCREEN
MEMORY" menu. Press the [MULTI] knob to open the
"3. SCREEN MEMORY" submenu.
Turn the [MULTI] knob to select "1. WRITE FILE".
Select "2. WRITE FILE" from the pulldown menu, and
then press the [MULTI] knob to start saving.
When you start to write the screen "WRITE..." appears
in the lower right part of the screen, as shown in the
diagram on the left, so you know that writing has
started.
If no compact flash card has been inserted, or if writing
the screen does not end normally, the message
"WRITE NG" appears as shown in the diagram on the
right.
Confirm that a card has been inserted, as indicated by
"CARD" in the diagram on the left.
6-5
6
6 Operation Settings
Advertisement
Table of Contents
