Table of Contents
Advertisement
7
1) Turn the [MULTI] knob to select the signal that you want to confirm. Press the [MULTI] knob
to accept.
Selecting NAV1 displays the data from the upper tier of the area from which the signal was
received. This is displayed in ASCII code on the right side. Additionally, if NMEA is not received
normally from the outer signal of NAV1 to NAV4, it repeatedly searches for the baud rate in the
→
→
order of 1200 bps (for JRC)
4800 (NMEA)
9800 (JRC, Gyro I/F).
2) If you want to stop signals to confirm, move the [MULTI] knob to the "STOP" position.
Pressing the [MULTI] knob to assign it stops the signals.
3) To clear the receive and transmit screens, move the [MULTI] knob to "CLEAR". You can
clear the screen by pressing the [MULTI] knob.
4) To stop LINE MONITOR, select "EXIT" with the [MULTI] knob. Pressing the [MULTI] knob
closes the specialized screen for LINE MONITOR.
7-15
7 Other Items
Advertisement
Table of Contents
