Preparation
1.1
Installing GTWIN
4. Enter the name of the file on which the function is to be run.
CAUTION
•
In order to use GTWIN, Windows 95 (OSR2 (Ver. 4.00.950B) or higher),
Windows 98, Windows Me, NT (Ver. 4.0 or a subsequent version) or
2000 must be installed in the computer.
•
The computer in which GTWIN is being installed must have at least 20
Mbyte of hard disk space available.
•
The above explanation assumes that Windows is installed in the C:
drive and that the CD drive is the E: drive. If your drives are
configured differently, or if you are installing the program over a
network, enter the appropriate drive name for your configuration.
5. A confirmation message is displayed.
186
GT10/GT30
When "Run" is selected, the
dialog box shown at the left is
displayed. Enter:
e:\setup.exe
and click on the [OK] button.
Note: The drive in which the
CD is installed may be called
by a name other than "e",
depending on the computer
configuration.
When the setup program is
booted, a confirmation dialog
box is displayed. Confirm the
contents and click on the
[Next] button. To interrupt the
installation, click on
[Cancel].