NAiS GT10 Technical Manual page 178

Servicing and Maintenance
8.3 Replacing the Front Panel Protective Sheet
8.3 Replacing the Front Panel Protective Sheet
8.3.1 About the Front Panel Protective Sheet
In order to protect the touch panel and keep it clean, the GT main unit comes with a
protective sheet attached over the panel. If this protective sheet becomes dirty or worn,
it should be replaced. Replacement sheets are available as an optional item.
Product name
Front panel protective sheet p p
8.3.2 Replacing the Front Panel Protective Sheet
Follow the steps below to replace the sheet:
1. Remove the attached front panel protective sheet.
First, peel off the front panel protective sheet already attached to the GT main unit,
starting from the upper left edge, where the knob is.
2. Peel off the seal from the provided protector sheet and attach it to the unit.
Take out one of the replacement front panel protective sheets and peel off the seal with
the shiny side. When attaching the sheet, align the adhesive edges with the front of the
GT main unit.
3. Finish by peeling off the thin film attached to the top of the front panel protective
sheet.
Peel off the front film.
Front
150
Contents
Front panel protective sheets for replacement (set of 10) p p p (
Adhesive face (attached seal)
GT10/GT30
Product number
) For GT10 AIGT180
For GT30 AIGT380