NAiS GT10 Technical Manual page 110

GT10 Configuration Settings
5.2 Entering Configuration Settings from GTWIN Screen Creation Tool
Device used
This specifies the internal PLC device used for basic communication between the GT10
and PLC.
·
Word area - - - This specifies the type of device that reads and writes screen
numbers and other information in word units, and the initial address.
·
Bit area - - - This specifies the type of device that reads and writes backlight
control and other bit information, and the initial address.
The type of device and addresses can be set by clicking on the
various items.
Device settings dialog box
REFERENCE
For detailed information on the basic communication area map, see
"GT10 Basic Communication Area Map" on page 36.
Explanation of this function
Standard settings
Clicking on the
following message. Clicking on [OK] sets the default values (the configuration settings
entered when the unit is shipped) for all of the settings.
For information on the contents of configuration settings entered when the unit is
shipped, see "Contents of configuration settings for GT10 when shipped from the
factory" on page 31.
82
Clicking on the
menu. Select the device for which settings are
to be entered, and use the ten - keys to enter
addresses.
The button functions as a backspace
key when entering addresses.
The button acts as a Clear key.
button in the "GT Configuration" dialog box displays the
buttons for the
button displays a pull - down
GT10/GT30