GT10/GT30
GT internal device hold
"GT Internal Device Hold" is a function that backs up the values for an internal device
(GWR or GDT) in the GT main unit.
Data registers
Don't hold
. .
The GT internal device hold function is turned off.
Hold
. . . . . . .
The GT internal device hold function is turned on.
Internal relays
Don't hold
. .
The GT internal device hold function is turned off.
Hold
. . . . . . .
The GT internal device hold function is turned on.
If the above setting for the GT internal device hold function is set to "Hold", a "Start No."
item is displayed. Click on the
below, and specify a starting number. After the setting has been entered, the contents
of any addresses subsequent to the specified value will be held.
Value setting dialog box
Key points
GT internal devices
Device type
Memory
y
Bits
* The WGR and GR are the same memory, but in the WGR, bits are handled in word units.
5.2 Entering Configuration Settings from GTWIN Screen Creation Tool
button to display the value setting dialog box shown
Enter the starting number, using the ten - key pad.
The
entering addresses.
The
Address range
Data register
GDT0000 to GDT2047
Internal relay
WGR0000 to WGR0255
Internal relay
GR0000 to GR255F
button functions as a backspace key when
button acts as a Clear key.
Points
2048 words
256 words
4096 points
GT10 Configuration Settings
95