How To Start Incubation - Rcom INSECT MAX 70 User Manual

USA & Canada Official Sales & Service https://www.R-Com-Hatcher.com

How to Start Incubation

▶ If you connect power cord, incubator starts
incubation with factory set conditions.
[Factory setting : Temperature 35.0℃ (95℉),
Humidity RH 60%]
※ Start incubation with required temperature
& humidity for your species of birds.
There can be some odor the first time
you use incubator, which is normal.
▶ The first time you connect power, FND light will blink and
pump will work for about 2sec. Then, incubator version
will be indicated on FND for about 1 sec.
▶ After version indication, buzzer sounds for about 15sec.
At the same time, present temp. & humidity displayed and
power failure alarm indication ⓐ is blinking.
▶ Press
(Buzzer will be removed automatically after 15sec.)
※ Notice of Power Failure : If power is turned off and then
on again because of power failure or by mistake, first dot
will blink.
Quick Start : If you just connect power, it automatically
starts incubation with factory setting. [Factory setting :
Temperature 35.0℃ (95℉), Humidity RH 60%]
▶ Incubator display current temperature and humidity, and it goes to setting conditions within an hour.
※ The artificial intelligence system memorizes and classifies ambient conditions for keeping optimum temperature,
and temperature can move up slowly at the first stage.
DIGITAL INCUBATOR
3. Incubation
button to remove buzzer and alarm indication.
Insect Incubator Rcom Max 70 User Manual
(2) Incubation Start /
Incubation Termination
IN
OUT
Pump Power Pump Power
Power Cord Power Cord
15