Table of Contents
Advertisement
USA & Canada Official Sales & Service https://www.R-Com-Hatcher.com
2. Before use
How to Control Water Flow Speed in APS
▶ The amount of water for humidification can be easily
controlled with APS.
▶ With cross type screw driver, turn "Speed" clockwise
to increase water flow and vice versa to decrease.
▶ To prevent water over flowing and dropping down in to
the chamber, it is recommended to use the APS with
lowest water flow speed. (1 drop of water in 3 sec.)
Humidity will raise up very slowly as artificial intelligence function check and memorize ambient conditions
to keep incubator inside with optimum conditions.
How to Replace the Tube
▶ If the silicone tube wear out and it does not pump water effectively, you should replace silicone tube.
[Refer to the page 13]
Be sure to use the silicon tube supplied from Autoelex(Rcom). (Ø2.6 × 3.5)
If water does not flow out even if pumping motor is working, check if silicon tube is blocked or folded.
※ If it failed in pumping water, check direction of IN and OUT again, and also check if motor is turning with anti-
clockwise. Also, length of silicon tube should be 35mm and inserted correctly. [Refer to the page 13]
Storage and Cleaning
▶ Do not wash APS with water but wipe with soft cloth.
▶ In case of long time storage, detach the silicon tube from the APS and remove the water from the tube.
Keep the tube unkinked. It stops the tube hole from blocking.
▶ When assembling again, stretch the tube to open the hole in case the tube is blocked.
12
(3) APS Assembly / Speed Control /
Tube Replacement/ Storage and Cleaning
Insect Incubator Rcom Max 70 User Manual
OUT
OUT
1 drop per 3 sec.
DIGITAL INCUBATOR
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the INSECT MAX 70 and is the answer not in the manual?
Questions and answers