Rfid Calibration (Available For Td-4650Tnwbr And Td-4750Tnwbr Only); Select The Antenna Position; Rfid Calibration Procedure - Brother TD-4650TNWB User Manual

8.2 RFID Calibration

8.2.1 Select the Antenna Position

Check the label to determine the best position for the antenna, locating the antenna loop within
the tag. In most cases, the antenna loop is directly above or below the chip. The loop may be
off to one side of the chip in some tags.
Open the Roll Compartment Cover. Move the Antenna Slide so that the Position Indicator
aligns with the loop in the tag.
Position Indicator

8.2.2 RFID Calibration Procedure

Note
For optimal calibration results, perform Media Calibration before RFID Calibration. Make sure
you correctly install both the ribbon and the label roll.
1. Perform Media Auto Calibration:
Using the LCD menu:

a. Load the RFID media into the printer.
b. (Thermal transfer only) Load the ribbon into the printer.
c. Select the Menu
(available for TD-4650TNWBR and TD-4750TNWBR only)
Antenna Slide
Numbered
Position Strip
.
56