5.1.3 Printer Initialization
Printer initialization clears the printer's DRAM and restores its factory settings.
1. Turn off the printer.
2. Press and hold the Feed/Pause button, and then turn on the printer.
3. Release the button after the amber LED flashes five times and the LED is lit in green/red.
Note
The LED color will change as follows:
Amber (lit) red/amber (5 times) amber (5 times) green/red (5 times) green (5 times)
red (5 times) green (lit)
After the initialization, the following factory settings will be restored:
Parameter
Speed
Density
Label Width
Label Height
Sensor Type
Gap Setting
Print Direction
Reference Point
Offset
Tear Mode
Peeler Mode
Cutter Mode
Code Page
Country Code
Clear Flash Memory
Default setting
76 mm/sec (3 ips)
8
4" (101.5 mm)
4" (101.5 mm)
Gap sensor
0.12" (3 mm)
0
0,0 (upper left corner)
0
On
Off
Off
850
001
No
31