Brother TD-4650TNWB User Manual page 50

Item
This submenu is used to perform an RFID calibration. The user must perform
a tag calibration when installing a new tag in the printer. RFID calibration
determines the RFID chip type, the write/read power, program position, and
the length of the EPC/User field.
RFID
Calibrate
Num Label
for
Calibration
Tag
Calibration
Test EPC
Length
Contains the settings used for optimal tag encoding. These parameters can
be obtained automatically through RFID calibration.
Tag
Position
Write
Power
Calibration
Param
Read
Power
Description
Performs the RFID calibration.
Execute it every time you change the RFID tag type.
Determines the number of tags to use for calibration.
However, this value does not include tags moved when
seeking gaps during the calibration process. Depending on
the difficulty in calibrating the installed tags, the printer may
use more or fewer labels, but generally, the greater the
number selected in this menu, the more tags will be used
to determine the calibration result. The default value (3) is
most commonly used.
Minimum 3 (Default)
Maximum 7
Determines the size of the EPC data that will be used to
perform the RFID calibration. This length can be increased
to improve the accuracy of the RFID calibration, but it
should not be increased to a value greater than the
maximum EPC length that the current Tag Type can
support.
Minimum 16
Maximum 256
Default 96
Determines how far the RFID tag encoding position of the
currently installed tag should be offset from Top of Form.
Specifies the write power level to be used in the RFID
encoder. Normally, this value is set automatically by the
RFID calibration process and should not be changed.
Minimum 1
Maximum 25
Specifies the read power level to be used in the RFID
encoder. Normally, this value is set automatically by the
RFID calibration process and should not be changed.
Minimum 1
Maximum 25
46