Table of Contents
Advertisement
Setting
AC Adapter
• If you connect the AC adapter to the P-touch labeling system after you specified "Auto Power
Off", the setting for "AC Adapter" becomes valid.
• The default value is "1hr." for the AC Adapter and "30min." for the Li-ion battery.
• Be sure to feed tape to remove any slack in the tape and ink ribbon after inserting the tape
cassette.
• Do not pull the label coming out of the tape exit slot. Doing so will cause the ink ribbon to
be discharged with the tape. The tape may no longer be functional after the ink ribbon
discharges.
• Do not block the tape exit slot during printing or when feeding tape. Doing so will cause the tape
to jam.
Feed & Cut
The Feed & Cut function feeds 0.96" (24.5mm) of blank tape, and then cuts the tape.
1
Press the Feed & Cut key.
"Feed & Cut?" will appear on the LCD display.
2
Using the
or
The message "Feeding Tape... Please Wait" appears while the tape is fed, and then the
tape is cut.
To exit or cancel this function press Esc.
Feed Only
This function will advance the tape approximately 0.96" (24.5mm), resulting in a blank label
sticking out of the tape cassette. This action is recommended when using Fabric tapes, which
should be cut using scissors.
Auto Power-Off Time
Value
Off
10min.
20min.
30min.
40min.
50min.
1hr.
2hr.
4hr.
8hr.
12hr.
Feeding Tape
key to select the "Feed & Cut" and then press either OK or Enter.
Setting
Li-ion Battery
Value
Off
10min.
20min.
30min.
40min.
50min.
1hr.
33
Feeding Tape
Advertisement
Table of Contents
