1: Component Replacement
Removing the Rear Fan Assembly
42
Use the following procedure to remove the rear fan assembly (refer to Figure 1-18 on page 45):
Warning:
You must disconnect the workstation from site power (by disconnecting the AC
power cords from the power outlet) before you attempt to service any internal components.
Failure to maintain proper safety measures while accessing internal components can expose
you to dangerous power levels, resulting in injury or death.
1.
Access the rear fan assembly (refer to "Accessing the Rear System Fans" on page 39).
2. Remove the two Phillips screws (one at the top of the fan assembly and one at the bottom of
the fan assembly) that secure the fan assembly to the enclosure.
3. Tip the fan assembly away from the enclosure and lift the fan assembly out of the enclosure.
007-5650-001