AMBROGIO BASIC User Manual page 77

PROGRAMMED MAINTENANCE INTERVALS CHART
Frequency Component
Every month Wheel drive
Every week Blade
Battery recharge
Every week
knobs
Robot
ROBOT CLEANING
1-Clean all the outside surfaces of the
robot with a sponge soaked in warm
water and neutral soap and rinse
properly.
2-Do not use solvents or benzine so not
to damage the varnished surfaces
and the plastic components.
3-Do not wash the inside parts of the
robot and do not use water jets in
pressure so not to damage the elec-
tric and the electronic components.
Warning - Caution
In order not to irreversibly damage the
electric and electronic components, do
not plunge the robot, partially or com-
pletely in water, as it is not watertight.
Type of intervention
Check the chain
tension
Controllare la tensione
delle catene
Clean and check the ef-
ficiency of the blade
If the blade is bent due
to an impact or if it is
worn-out, replace it
Clean and remove any
oxidations
Carry out cleaning
4-Check the lower part of the robot
(cutting blade area and wheels) and
remove the deposits and/or resi-
dues that might obstruct the correct
functioning of the robot.
To remove the deposits and/or oth-
er residues from the blade, use a
suitable brush.
Warning - Caution
Use protection gloves to avoid the risk
of cuts on hands.
5-Clean the battery recharge knobs
and remove any deposits due to elec-
tric contacts with a dry cloth and, if
necessary, with fine-grained abrasive
paper.
- 35 -
Reference
see "Chain tension
adjustment"
see "Robot clean-
ing"
see "Replace the
blade"
see "Robot cleaning"
see "Robot cleaning"
User's manual
GB