AMBROGIO BASIC User Manual page 69

To restart the robot, proceed as shown.
3-Press again shortly the "start" (A)
push button or (L).
The led (E) (green) and (H) (yellow)
ROBOT START WITHOUT PERIMETER WIRE
This mode can be carried out with the re-
mote control to perform the trimming of
areas completely marked by fences or to
trim, for example, small areas, where it
was not possible to mark or for practical
demonstrations on the functioning of the
robot
Important
When the robot is used without the pe-
rimeter wire, it is recommended to
make sure that the robot does not hit
into obstacles, corners or blunt ob-
jects so to avoid damages or breaks.
1-Press for an extended time (about 3
seconds) the "start" (A) push button
and release it when the leds (E-F-G-H)
start flashing.
The "without perimeter wire" mode is
indicated by the led (E) (green) flash-
ing and by the led (H) (yellow) off.
ROBOT SAFETY STOP
When using the robot, it may necessary
to stop it in safety conditions to avoid the
ranger to a sudden start of the blade.
Important
The stop of the robot in safety condi-
tions is necessary in order to carry out
maintenance and repair interventions
(for example: battery replacement
and/or recharge, blade replacement,
cleaning operations, etc.)
turn on. The robot, with the blade on,
starts trimming the lawn inside the
area marked by the perimeter wire.
Important
The mode is used to delete the identifi-
cation of the perimeter wire, in case it
is installed.
2-Press shortly the "start" (A) push but-
ton or (L).
The led (E) (green) turns on, while the
led (H) (yellow) remains off. The ro-
bot, with the blade on, starts trim-
ming the lawn of the area.
Important
It is advisable to operate the robot with
the remote control to carry out the
trimming inside a narrow area, well vis-
ible and to avoid, if possible, making it
hit into obstacles.
To stop the robot, press the "stop" (B)
push button.
Warning - Caution
To stop the robot in safety conditions,
it is not enough to press the "start" (L)
push button, but it is necessary to then
press the "stop" (B) push button as
well.
- 27 -
GB
User's manual