AMBROGIO BASIC User Manual page 72

BATTERY RECHARGE
1-Turn off the robot and place it
near the transmitter.
The led (E) (red) on indicates
that the batteries have com-
pletely run down.
Important
It is advised to carry out battery
recharge with the robot off, al-
though automatic turning off is
foreseen if the robot remains on
during procedure.
GB
2-Connect the connector (G)
(red, polarity +).
3-Connect the connector (H)
(black, polarity -).
Warning - Caution
A wrong connection of the poles
may irreversibly damage the bat-
teries and the electronic cir-
cuits.
Until the led (E) (red) of the power
supply unit (F) remains on, the bat-
tery is not completely charged.
The completion of the recharge is
indicated by the turning on of the
led (E) (green).
Important
To obtain an optimal recharge of
the batteries, it is necessary to
leave them in charge until the led
turns off (E).
To obtain a complete recharge of
the batteries, it is advised to keep
them connected to the recharge
unit for about 3÷4 hours (to as-
sess also according to the general condi-
tions of the batteries).
Important
In case of 2 completely run-down lithi-
um batteries 4÷5 recharge hours are
required.
connector (H)
power supply unit (F)
led (E)
4-Disconnect the connector (G) (red,
polarity +).
5-Disconnect the connector (H) (black,
polarity -).
Important
At the first recharge, the batteries
must be connected at least 24 hours.
- 30 -
connector (G)
IDM - 41501603600.tif
led (D)
transmitter (B)
IDM - 41501601900.tif
User's manual