AMBROGIO BASIC User Manual page 62

2-Reassemble body cover (E)
and tighten screws (D).
GB
3-Assemble the hood (B).
Important
When reassembling the hood,
the hole (T) must be matching
with the referring plug. This as-
sures the correct functioning of
the battery polarity.
4-Fasten knobs (A).
5-Install the blade (see "Blade in-
stallation").
Warning - Caution
Before performing the first re-
charge, check that the power
supply unit is suitable for the
type of batteries installed (power
supply unit for lead or lithium
batteries).
Important
Before using the robot, perform a
complete recharge of the new bat-
teries (see "Battery recharge").
At this point, the robot is ready to
use (see "Use and functioning").
connector (C)
screw (D)
connector (C)
hole (T)
- 20 -
guard (E)
IDM - 41501602200.tif
hood (B)
IDM - 41501602600.tif
knob (A)
IDM - 41501602100.tif
User's manual