AMBROGIO BASIC User Manual page 70

ROBOT AUTOMATIC STOP
The robot stops automatically
when the listed conditions occur.
1) Run-down batteries: The con-
dition is indicated by the turn-
ing on of the led (D) (red)
relating to the batteries.
2) Rain: the condition is indicated
by the flashing turning on of the
led (E) (green) and led (G) (blue).
When the robot stops in "rain"
conditions, it can be restarted
with a voluntary action.
GB
To restart the robot, press
shortly the "start" (A) push but-
ton or (L).
The robot restarts trimming
the lawn.
To disable the "rain" detection
sensor, stop the robot with the
"stop" (B) key.
To restart the robot during
rain, see "Manual start and
stop of the robot". In such conditions,
the "rain" detection sensor automati-
cally deactivates.
Once it stops raining, it is possible to
reactivate the "rain" detection sensor
by means of the "stop" (B) push button
and by repeating the start procedures
(see "Manual start and stop of the ro-
bot")
3) Trimmed lawn: the sensor (optional in
the BASIC version) detects the
trimmed lawn.
The condition is indicated by the flash-
ing turning on of the led (E) (green) and
by the turning on of the led (G) (blue).
When the conditions of "run-down bat-
teries", "rain" or "trimmed lawn" occur,
the robot reaches the nearest perime-
ter wire and stops in the "stand-by"
mode to reduce the consumption of
batteries.
The "stand-by" mode is indicated by the
turning off of the leds (E-F-G-H) and eve-
ry 5 seconds by the turning on of the
leds of the batteries that indicate the
stand-by condition and their charge lev-
el.
led (F)
push button
(A)
push button
(B)
led (G)
push button (L)
(M)
push button
(P)
push button
Important
After pressing the "start" (A) push but-
ton, according to the type of leds turn-
ing on ,it is possible to detect the
reason of the stop and/or the causes,
for which the robot does not restart
(see "Troubleshooting")
According to the point, where the robot
stops, it is possible to recognize the rea-
son of the stop.
Robot stop above the perimeter wire: it
indicates that the battery has run down.
Robot stop inside the perimeter (at
about 1 m from the perimeter wire): it in-
dicates that the lawn is trimmed or
there is rain.
Important
It is possible to restart the robot only
after retrieving the normal operation
conditions.
If the stop was not due to run-down
batteries, the robot will restart auto-
matically 24 hours later from the first
start.
- 28 -
led (E)
led (C)
led (D)
led (H)
push
button (N)
IDM - 41501603000.tif
User's manual
batteries